B500 Logo
Slot Car Bracket Drag Racing

Library Old Articles
Projects on Bracket500
Chat Room Mondays
Instructional Links
World Tribute Car
Spec Cars
All Car Galleries
Slip Joint 101
Front Page
Contact Bracket500
Message Board

You are not logged in. Would you like to login or register?

1/19/2020 6:01 am  #1

Koford Hawk6 setup with 19 arm

I have read through the motor thread and read everything related to this motor.
I have checked brush hoods, fixed the brush issue and went to light springs.
I am putting this motor in a hardtail setup using the ESR chassis.
Rears are 1.1750 after cleaning and truing, JDS rubber, 400 wide.

Will be on 1/4 mile track, NO GLUE. I currently have it 15/52 but am not sure if this is a good starting point.



It is not always possible to be the best, but it is always possible to improve your own performance.

Board footera


Powered by Boardhost. Create a Free Forum

B500 Logo
Return to Main

WRP Products

Return to Main
Click on banners to see catalogs
Copyrights reserved ©2014