B500 Logo
Slot Car Bracket Drag Racing

Library Old Articles
Projects on Bracket500
Chat Room Mondays
Instructional Links
World Tribute Car
Spec Cars
All Car Galleries
Slip Joint 101
Front Page
Links
Tracks
Contact Bracket500
Bracket500
Message Board

You are not logged in. Would you like to login or register?



1/28/2015 2:17 pm  #1


no-bar driveshaft builds

This has been finished for a while, but I'm just getting around to sharing it. B&B driveshaft rail, DRS wedge body. Absolutly hates glue, 1"x.300 tires.

Initially it had a gp 12 motor, ran well, but that motor suffered a catastrophic magnet failure & went up in smoke on the start line. Has since been replaced with a Big Block 20 in a Parma 499 setup, but the current 14/52 gearing comes off the line too soft, turning 1.03 - 1.08 times. Planning on dropping down to an 11tooth pinion, hoping to get into the nines.
Since this picture the rear body mount has been moved much closer to the rear of the chassis, and above the rear tires to provide support to the rear of the body. 
http://i1267.photobucket.com/albums/jj558/Ben_Kernan/driveshaftfinal.jpg

Anyone else built a driveshaft??

Last edited by Macman (1/28/2015 2:29 pm)


Formerly of SARN
 

Board footera

 

Powered by Boardhost. Create a Free Forum






B500 Logo
Return to Main

WRP Products

Return to Main
Click on banners to see catalogs
 
Copyrights reserved ©2014