B500 Logo
Slot Car Bracket Drag Racing

Library Old Articles
Projects on Bracket500
Chat Room Mondays
Instructional Links
World Tribute Car
Spec Cars
All Car Galleries
Slip Joint 101
Front Page
Links
Tracks
Contact Bracket500
Bracket500
Message Board

You are not logged in. Would you like to login or register?



2/11/2013 3:09 pm  #1


Installing bushings/bearings made easy

It's fairly easy to install bushings/bearings.
What you will need.
   http://bracket500.com/mb/bu1.jpg

Pic 1. An old set of tires, axle, motor mount, bushings, acid flux and solder.

Here's how to install
  http://bracket500.com/mb/bu2.jpg

Pic 2. Motor mount needs to be cleaned to ready for soldering.
Pic 3. Cleaned brass motor mount.
Pic 4. Apply acid flux
Pic 5. Apply solder. (Also known as tinning)
     http://bracket500.com/mb/bu3.jpg

Pic 6 place bare bushing and motor mount side on wheel, then on the top
motor mount opening place your bushing and solder it.
Pic 7. Reverse the motor mount with bushing that's soldered to the bottom wheel and
reapeat soldering for the top bushing. Clean all parts with cleaner and then use
soap and water, dry everything well. The motor mount is ready to be installed on
the chassis.

 Now some racers prefer to glue the bushings/bearings in. Maybe some one can
show you how that's done.

  DVan


 


"Where legends are made and records are broken".
 

Board footera

 

Powered by Boardhost. Create a Free Forum






B500 Logo
Return to Main

WRP Products

Return to Main
Click on banners to see catalogs
 
Copyrights reserved ©2014