B500 Logo
Slot Car Bracket Drag Racing

Library Old Articles
Projects on Bracket500
Chat Room Mondays
Instructional Links
World Tribute Car
Spec Cars
All Car Galleries
Slip Joint 101
Front Page
Links
Tracks
Contact Bracket500
Bracket500
Message Board

You are not logged in. Would you like to login or register?



11/13/2012 11:07 am  #1


gluing up a neo car

question for those with neo experience.  say you have a velociraptor xtreme fc.  You have a clean bare track to start with.  what steps do you take to glue the track up before a pass.  koford light, heavy...a mix??? roll out to 100ft, 660ft?? what technique are you using? thanks, Joe

 

11/13/2012 11:08 am  #2


Re: gluing up a neo car

*assuming the chassis is set up correct and all is right with the car* what should it require to make the car go down?

     Thread Starter
 

11/13/2012 4:27 pm  #3


Re: gluing up a neo car

so two beads of glue from start to 1000', then use roller? do you ever use a little of heavy/medium in the 60?

     Thread Starter
 

11/15/2012 11:28 am  #4


Re: gluing up a neo car

Just make sure the track is glued with the light only about a little pasted the 660 then run a few other cars down the track to take down the glue down the track.  Use the light only with the extreems these cars will run in the glue at 350 wides to .400 wides.  Gearing to tire height will varey.  A good tire height to start is at 1.065 at a 15/54 rim sizes best to me are at .500 to scale at .635.  Good luck

 

Board footera

 

Powered by Boardhost. Create a Free Forum






B500 Logo
Return to Main

WRP Products

Return to Main
Click on banners to see catalogs
 
Copyrights reserved ©2014